Hur Löser jag detta på enklaste sätt?? Jag förstår inte hur jag skall gå tillväga för att göra detta "manuellt" eller på det andra sättet. Behöver du hjälp med översättningen, eller vad är det du inte förstår? Visst kan jag starta en dospromt. Jag har provat skriva exakt som det står, men jag får bara ett felmeddelande när jag trycker >enter<. Jag undrar om jag skriver fle när jag försöker göra detta? Vad är det för någonting du skall registrera? Om du vet vad det är så kan du ta reda på var det ligger, och du får då istället använda den filen. (om du med exakt menar ordagrant)Registering the Control
Registering the Control
Before you add an ActiveX control to your dialog window, you need to register the control, both with Windows and with Visual C++. There are two possible ways to register the ActiveX control with Windows. The first way is to run any installation routine that came with the ActiveX control. If you do not have an installation routine, you need to register the control manually. To register the control manually, follow these steps:
1. Open a DOS shell.
2. Change directory to where the ActiveX control is on your system.
3. Run the regsvr32 command, specifying the name of the ActiveX control as the only command-line argument. For instance, if you were registering a control named MYCTL.OCX and it was located in your WINDOWS\SYSTEM directory, you would perform the following:
C:\WINDOWS> CD system
C:\WINDOWS\SYSTEM> regsvr32 MYCTL.OCXSv: Registering the Control
Om du inte kan starta en MS-DOS-prompt så kan du skapa en genväg eller en .bat-fil
/Niklas JanssonSv: Registering the Control
Sv: Registering the Control
/Niklas Jansson